First Steps for a new Klipper Machine ( Enter the commands in Console )

• PID Tune Hotend with

  • PID_CALIBRATE HEATER=extruder TARGET=195

• PID Tune Bed with

  • PID_CALIBRATE HEATER=heater_bed TARGET=60

• Verify stepper motors

  • STEPPER_BUZZ STEPPER=stepper_x ( Replace stepper_x with any motor you like Y, Z etc )

Calibrate your Extruder using my calculator above

• Calibrate your Pressure Advance using the Ellis tuning guide

  • Here I like to use Orca Slicer for this

• Calibrate your Extrusion Multiplier or Flow

  • Here I like to use Orca Slicer for this also

Start Gcode for your slicer

Cura

print_start EXTRUDER={material_print_temperature_layer_0} BED={material_bed_temperature_layer_0} CHAMBER={build_volume_temperature}

Orca Slicer

M104 S0 ; Stops OrcaSlicer from sending temp waits separately

M140 S0

print_start EXTRUDER=[first_layer_temperature] BED=[first_layer_bed_temperature] CHAMBER=[chamber_temperature]